When your garage door won't open, the first question is usually simple: what is this going to cost me? The good news is that most garage door repairs in 2026 land in the low hundreds, not the thousands. Here is what the common fixes actually run, what moves the price, and how to spot a fair quote.
A quick note on these numbers: they are typical ranges for 2026 that include parts and labor for a standard residential door. Bay Area labor tends to run a little higher than the national average, and the only price that truly matters is a written quote for your specific door — which we give before any work starts.
Key takeaways
- Most repairs are low hundreds, not thousands
- Replace both springs together to save a second call
- Repair openers under 7 years old; replace over 12
- Never DIY springs or cables — the tension is dangerous
- Always get a written, itemized quote first
Garage door repair prices at a glance (2026)
Commercial and oversized doors run higher, and emergency or after-hours visits add to the price.
| Single torsion spring (installed) | $150–$350 |
| Pair of springs | $250–$450 |
| Extension springs | $120–$200 |
| Cables (both, installed) | $150–$350 |
| Opener repair (gear, capacitor, board) | $75–$220 |
| New opener installed | $250–$550 |
| Roller set | $80–$150 |
| Balancing / tune-up | $50–$150 |
| New door installed | $700–$3,500 |
Broken springs — the most common (and most feared) repair
Springs are the number-one repair, and the one people dread most. A single torsion spring installed usually runs $150 to $350, and a pair $250 to $450. Springs are rated for roughly 7 to 14 years of normal use, and both wear at the same rate — so if one snapped, the other is close behind. Replacing both at once saves you a second service call.
This is never a DIY job. A wound spring holds enough force to cause serious injury.
Opener repair or replace?
An opener that grinds, reverses, or won't respond often has a failed gear, capacitor, or logic board. Small fixes run $75 to $220; a full opener replacement, installed, is typically $250 to $550 depending on drive type and smart features.
The rule of thumb: repair an opener under seven years old, replace one over twelve.
Cables, rollers, and tune-ups
Frayed or snapped cables cost $150 to $350 to replace (both cables, for balance). A full set of nylon rollers runs $80 to $150, and a balance/tune-up is $50 to $150. Because cables tie into the spring system, a good technician always checks spring balance at the same time — otherwise the problem repeats.
What moves the price up or down
- Door size and weight — double and oversized doors cost more
- Spring type and cycle rating — high-cycle springs cost a bit more but last much longer
- One spring versus two
- Emergency or after-hours service
- Whether related worn parts need replacing at the same time
- Local labor rates — the Bay Area runs above the national average
How to spot a fair quote
- You get a written, itemized price before any work starts
- The technician diagnoses on site rather than quoting a complex job sight-unseen
- No pressure to replace the whole door when a repair will do
- A warranty on parts and labor, in writing
Need a hand with your door?
Same-day service, upfront pricing, licensed and insured.
Related services